Subaru 2002 IMPREZA Service Manual page 1087

B: INSTALLATION
1. FRONT SIDE BELT
CAUTION:
Wipe off any oil or water on the belt and pulley.
1) Install the belt (C), and tighten the slider bolt so
as to obtain the specified belt tension <Ref. to
ME(TURBO)-45, INSPECTION, V-belt.>
2) Tighten the lock bolt (A)
3) Tighten the slider bolt (B).
Tightening torque:
Lock bolt through bolt:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
Slider bolt:
8 N·m (0.8 kgf-m, 5.5 ft-lb)
(B)
2. REAR SIDE BELT
1) Install the belt, and tighten the slider bolt (B) so
as to obtain the specified belt tension. <Ref. to
ME(TURBO)-45, INSPECTION, V-belt.>
2) Tighten the lock nut (A).
Tightening torque:
Lock nut (A);
22.6 N·m (2.3 kgf-m, 16.6 ft-lb)
V-BELT
(C)
(A)
EN0225
(B)
(A)
EN0226
ME(TURBO)-45
C: INSPECTION
1) Replace the belts, if cracks, fraying or wear is
found.
2) Check the drive belt tension and adjust it if nec-
essary by changing generator installing position
and/or idler pulley installing position.
Belt tension
(A)
replaced: 7 — 9 mm (0.276 — 0.354 in)
reused: 9 — 11 mm (0.354 — 0.433 in)
(B)*
replaced: 7.5 — 8.5 mm (0.295 — 0.335 in)
reused: 9.0 — 10.0 mm (0.354 — 0.394 in)
*: with air conditioner
C/P Crankshaft pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
MECHANICAL
EN1179