Subaru 2002 IMPREZA Service Manual page 1081

(6) Tighten the plug.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb)
2) Install the front cushion rubbers to engine.
Tightening torque:
34 N·m (3.5 kgf-m, 25.3 ft-lb)
3) Install the engine onto transmission.
(1) Position the engine in engine compartment,
and then align it with the transmission.
CAUTION:
Be careful not to damage the adjacent parts or
body panels with crank pulley, oil pressure
gauge, etc.
(2) Apply a small amount of grease to the
splines of mainshaft. (MT vehicles)
4) Tighten the bolts which hold right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
5) Remove the lifting device and wire ropes.
ENGINE ASSEMBLY
6) Remove the garage jack.
7) Install the pitching stopper.
S2M1846
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
8) Remove the ST from torque converter clutch
case. (AT vehicles)
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing ST.
ST 498277200
9) Install the starter. <Ref. to SC-6, INSTALLA-
TION, Starter.>
B2M2791
ME(TURBO)-39
MECHANICAL
G2M0297
H3M1839A
STOPPER SET