Subaru 2002 IMPREZA Service Manual page 1107

(5) Tighten the bolts (C), (D), (E) and (F) to 15
N·m (1.5 kgf-m, 11 ft-lb).
(6) Tighten all bolts by 80 to 90° in alphabetical
sequence.
CAUTION:
Do not tighten the bolts more than 90° ° ° ° .
(7) Further tighten all bolts by 80 to 90° in al-
phabetical sequence.
CAUTION:
Ensure the total "re-tightening angle" [in the
two previous steps] do not exceed 180° ° ° ° .
3) Install the camshaft. <Ref. to ME(TURBO)-60,
INSTALLATION, Camshaft.>
4) Install the A/C compressor bracket on cylinder
head.
5) Install the intake manifold. <Ref. to FU(TURBO)-
18, INSTALLATION, Intake Manifold.>
6) Install the camshaft sprocket. <Ref. to ME(TUR-
BO)-57, INSTALLATION, Camshaft Sprocket.>
7) Install the timing belt assembly. <Ref. to
ME(TURBO)-50, INSTALLATION, Timing Belt As-
sembly.>
8) Install the belt cover. <Ref. to ME(TURBO)-47,
INSTALLATION, Belt Cover.>
9) Install the crankshaft pulley. <Ref. to ME(TUR-
BO)-46, INSTALLATION, Crankshaft Pulley.>
10) Install the V-belt. <Ref. to ME(TURBO)-45, IN-
STALLATION, V-belt.>
CYLINDER HEAD ASSEMBLY
B2M1397D
ME(TURBO)-65
C: DISASSEMBLY
1) Remove the valve shims and valve lifters.
2) Compress the valve spring and remove the
valve spring retainer key. Remove each valve and
valve spring.
ST1 498267600 CYLINDER HEAD TABLE
ST2 499718000 VALVE SPRING REMOVER
CAUTION:
• Keep the removed parts in order for re-install-
ing in their original positions.
• Mark each valve to prevent confusion.
• Use extreme care not to damage the lips of
the intake valve oil seals and exhaust valve oil
seals.
MECHANICAL
S2M1881A