DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Step
9
CHECK HARNESS BETWEEN ECM AND
PRESSURE SENSOR CONNECTOR.
1)Turn the ignition switch to OFF and Subaru
Select Monitor or the OBD-II general scan tool
switch to OFF.
2)Disconnect the connector from pressure
sensor.
3)Turn the ignition switch to ON and Subaru
Select Monitor or the OBD-II general scan tool
switch to ON.
4)Read the data of intake manifold absolute
pressure signal using Subaru Select Monitor or
OBD-II general scan tool.
NOTE:
•Subaru Select Monitor
For detailed operation procedure, refer to the
"READ CURRENT DATA FOR ENGINE".
<Ref. to EN(TURBO)-34, Subaru Select Moni-
tor.>
•OBD-II general scan tool
For detailed operation procedures, refer to the
OBD-II General Scan Tool Instruction Manual.
Check
Is the value more than 282 kPa
(2121 mmHg, 83.50 inHg)?
EN(TURBO)-112
Yes
Repair the battery
Replace the pres-
short circuit in har-
sure sensor. <Ref.
ness between
to FU(TURBO)-35,
ECM and pressure
Pressure Sensor.>
sensor connector.
No