Subaru 2002 IMPREZA Service Manual page 1122

MECHANICAL
20) Apply fluid packing to the matching surfaces,
and then install the oil separator cover.
Fluid packing:
THREE BOND 1215 or equivalent
21) Install the drive plate. (AT vehicles)
To lock the crankshaft, use ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
72 N·m (7.3 kgf-m, 52.8 ft-lb)
22) Install the flywheel. (MT vehicles) <Ref. to CL-
24, INSTALLATION, Flywheel.>
23) Install the clutch disc and cover. (MT vehicles)
<Ref. to CL-20, INSTALLATION, Clutch Disc and
Cover.>
24) Installation of oil pump:
(1) Discard the front oil seal after removal. Re-
place with a new one using the ST.
ST 499587100 OIL SEAL INSTALLER
CYLINDER BLOCK
Fluid packing:
THREE BOND 1215 or equivalent
S2M1834A
ST
EN1118
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
CAUTION:
• Do not forget to install the O-ring and seal
when installing the oil pump.
• Align the flat surface of oil pump's inner rotor
with crankshaft before installation.
S2M0235
ME(TURBO)-80
(2) Apply fluid packing to the matching surface
of oil pump.
(A) O-ring
(3) Apply a coat of engine oil to the inside of the
oil seal.
(4) Install the oil pump on cylinder block. Be
careful not to damage the oil seal during instal-
lation.
B2M0390B
S2M0118B