Point-To-Point Protocol Over Ethernet (Pppoe); Chapter Conventions - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

C 16
HAPTER
E (PPP
THERNET
This chapter includes the commands for configuring Point-to-Point Protocol over
Ethernet (PPPoE) encapsulation on a Gigabit Ethernet interface. You are required
to refer to the
For instructions on using the PPPoE commands and descriptions on each of their
parameters, refer to the OmniAccess 700 CLI Command Reference Guide.
The chapter is divided into the following sections:
•
"PPPoE Overview"
•
"PPPoE Configuration"
C C
HAPTER ONVENTIONS
Acronym
CM
CPE
GigE
ICM
IPCP
LCP
PPP
PPPoE
PADI
PADO
PADR
PADS
CLI Configuration Guide
Beta
P - -P
OINT TO OINT
E)
O
"Ethernet Interfaces on SE"
Configuration Mode - ALU (config)#
Customer Premises Equipment
Gigabit Ethernet
Interface Configuration Mode - ALU (config-interface name)#
IP Control Protocol
Link Control Protocol
Point-to-Point Protocol
Point-to-Point Protocol over Ethernet
PPPoE Active Discovery Initiation
PPPoE Active Discovery Offer
PPPoE Active Discovery Request
PPPoE Active Discovery Session-Confirmation
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

Point-to-Point Protocol over Ethernet (PPPoE)

P
ROTOCOL OVER
chapter before proceeding with this.
Description
335
Beta