Igmp Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Multicast Routing
IGMP C
ONFIGURATION
To configure IGMP, perform the tasks described in the following sections. The
tasks in the first section are required; the tasks in the remaining sections are
optional, but might be required for your network.
T E M R
O NABLE ULTICAST
ip multicast-routing
E
XAMPLE
ALU(config)# ip multicast-routing
T E IGMP
O NABLE ON AN
ip pim sparse-mode
no ip pim sparse-mode
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
564
Beta
C
OMMANDS
OUTING
Command (in CM)
I
NTERFACE
Command (in ICM)
Alcatel-Lucent
Description
This command enables multicast routing
and forwarding on OA-700.
Multicast routing is disabled by default.
Description
Enter this command in the Interface
Configuration Mode.
This command is used to enable IGMP
on an interface.
After enabling this command, IGMP
learns the multicast host information on
given interface.
This command is used to disable IGMP
on an interface.
CLI Configuration Guide
Beta