Modify Global Vrrp Group Parameters - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

M G VRRP G
ODIFY LOBAL
It is recommended that the modifications to VRRP group global parameters are
done before enabling the VRRP group on the interfaces. Otherwise, this router
might become a master or a slave inadvertently before finishing the
customization.
For VRRP to be enabled on an interface for a group, the following three conditions
have to be met:
•
The primary address of the interface must be configured.
•
The operational state of the interface must be up.
•
The primary address of the group must be configured.
T C VRRP R
O ONFIGURE
Note: Priority cannot be changed for a VRRP group that is an IP address owner (i.e., VRRP
group address same as the interface address). The default priority for this group is set
to 255.
Command (in ICM)
vrrp <1-8> priority <1-254>
no vrrp <1-8> priority
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# vrrp 7 priority 104
CLI Configuration Guide
Beta
P
ROUP ARAMETERS
P
OUTER RIORITY
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command sets the priority for the
router for a specific VRRP group.
The "no" command restores the default
priority for the VRRP group.
The default priority is 100.
VRRP Configuration
139
Beta