Vrf Show Commands; Example - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

VRF S C
HOW OMMANDS
Command (in CM)
show ip vrf [interfaces
<vrf-name>]
show ip protocols [vrf
<vrf-name>]
show ip route [vrf <vrf-
name>] [{network-number|ip-
address/prefix length}
[longer-prefixes]|ospf [<1-
65535>]|connected|bgp|rip|
summary|supernets-only]
E
XAMPLE
ALU(config)# show ip vrf interfaces ALU
Interface
GigabitEthernet7/1
ALU(config)# show ip vrf interfaces ALU-vrf
Interface
GigabitEthernet7/0
ALU(config)# show ip protocols vrf ALU-vrf
Routing Protocol is "ospf 1"
Invalid after 3600 seconds, hold down 5, flushed after 3600 seconds
Router Id 4.4.4.4
Number of Areas in this router 1. 1 normal 0stub 0 nssa
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Routing for Networks:
4.0.0.0/8
Routing Information Sources:
Gateway
4.4.4.1
Distance: (default is 110)
Routing Protocol is "bgp 100"
IGP synchronization is enabled
Automatic route summarization is disabled
OA-780 CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Displays information on the defined VRF
instances.
•
The "interfaces" keyword gives the
information of the VRFs configured on all
the interfaces.
•
If the VRF name is specified, then it
displays all the interfaces associated with
the specified VRF.
Displays routing protocol information
associated with a VRF.
Displays the IP routing table for the default
VRF.
If the VRF name is specified, then it displays
the IP routing table for the specified VRF.
IP Address
1.1.1.1
IP Address
2.2.2.2
Distance Last Update
110 00:05:56
Alcatel-Lucent
VRF-CE Configuration
Description
VRF Protocol
ALU Down
VRF Protocol
ALU-vrf up
Beta
605