Verify Cac Configuration - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Call Admission Controller
Step 5: Enter Admission Control configuration mode, and configure a CAC object.
ALU(config)# admission-control
ALU(config-ac)# call-admission-control mycac
ALU(config-ac-cac-mycac)#
Step 6: Configure parameters within a CAC object.
ALU(config-ac-cac-mycac)# protocol sip bandwidth call-
threshold 20
Step 7: Enable CAC on an interface.
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)# admission-control cac
mycac
V CAC C
ERIFY ONFIGURATION
Verify the CAC configuration by using the following show commands:
ALU(config)# show admission-control cac mycac
call-admission-control mycac
protocol sip bandwidth call-threshold
interface GigabitEthernet7/0
admission-control cac mycac
ALU(config)# show admission-control statistics cac
Interface: GigabitEthernet7/0
Protocol SIP
Call-Threshold Statistics
Bandwidth Statistics
880
Beta
Call Threshold = 20
Active Call Count = 0
Priority Call Count = 0
Rejected Call Count = 0
Policy 1 Class 10
Total Bw = 100000 bps Used Bw = 0 bps
Alcatel-Lucent
20
CLI Configuration Guide
Beta