Dnat Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

DNAT C
ONFIGURATION
This section lists the steps to be followed while configuring DNAT.
Step 1: Configure the match-lists with the common classifiers pre-configured.
(Refer the "Common Classifiers"
Step 2: Enter the NAT Configuration Mode. See
Mode"
Step 3: Configure DNAT with host IP address or address pool See
DNAT"
Step 4: Configure DNAT optional parameters.
•
•
•
Attach configured DNAT to an Interface
Step 5: Enter into Interface Configuration Mode
Step 6: Administratively bring up the interface
Step 7: Configure IP address for the interface
CLI Configuration Guide
Beta
S
TEPS
in this guide.)
Configure port number for DNAT. See
DNAT"
Configure Static DNAT. See
Reorder the rules in the match-list for the configured DNAT. See
Reorder the Rules in DNAT"
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Destination NAT Configuration
"To Enter NAT Configuration
"To Configure Port Number for
"To Configure Static DNAT"
"To Configure
"To
629
Beta