Vrf-Ce Cli Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Virtual Routing and Forwarding
VRF-CE CLI C
OMMANDS
This section details the commands used in configuring VRF-CE.
T C VRF
O ONFIGURE
Command (in CM)
ip vrf <vrf-name>
no ip vrf <vrf-name>
E
XAMPLE
ALU(config)# ip vrf ALU-vrf
ALU(config-vrf)#
Note: Maximum number of VRFs supported is 64.
T C
O ONFIGURE
Command (in VRF CM)
description <description-
string>
E
XAMPLE
ALU(config-vrf)# description ALU-routing
596
Beta
D VRF
ESCRIPTION FOR A
Alcatel-Lucent
Description
This command is used to configure a VRF.
This enters the VRF Configuration Mode.
This command deletes the configured VRF.
All routing protocol configuration within the
VRF is removed.
Description
This command is used to specify description
for a VRF.
OA-780 CLI Configuration Guide
Beta