Pbr Configuration; Pbr Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

PBR C
ONFIGURATION
This section includes the following:
•

"PBR Configuration Steps"

•
"PBR Configuration Flow"
•
"PBR Configuration Commands"
PBR C
ONFIGURATION
This section lists the steps for configuring policy based routing on OA-700.
Step 1: Configure the match-lists using the common classifiers syntax. (Refer to
the chapter on
Step 2: Configure an IP policy. See
•
Attach an IP Policy to an Interface
Step 3: Enter into Interface Configuration Mode
Note: IP policy can be configured on any interface.
Step 4: Administratively bring up the interface
Step 5: Configure IP address for the interface
CLI Configuration Guide
Beta
S
TEPS
"Common Classifiers"
Configure a Rule inside an IP policy. See
Policy"
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
in this guide).
"To Configure an IP Policy"
"To Configure a Rule for an IP

PBR Configuration

579
Beta