V.35/X.21/Rs-232 Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

V.35/X.21/RS-232 C
This section provides details about the commands that are used in configuring the
V.35/X.21/RS-232 interface.
T C S
O ONFIGURE A ERIAL
interface Serial <slot/port>
E
XAMPLE
ALU(config)#interface Serial0/0
ALU(config-if Serial0/0)#
T B U /D S
O RING P OWN A
no shutdown
shutdown
E
XAMPLE
The following example administratively brings up the V.35/X.21/RS-232 interface:
ALU(config)#interface Serial 0/0
ALU(config-if Serial0/0)# no shutdown
The following example administratively brings down the V.35/X.21/RS-232
interface:
ALU(config)#interface Serial 0/0
ALU(config-if Serial0/0)# shutdown
CLI Configuration Guide
Beta
C
ONFIGURATION OMMANDS
I
NTERFACE
Command (in CM)
(V.35/X.21/RS-232) I
ERIAL
Command (in ICM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
V.35/X.21/RS-232 Configuration
Description
Enters Serial Interface Configuration
Mode.
This command is entered in the
Configuration Mode to configure a serial
interface in a specific slot/port of the
V.35/X.21/RS-232 card.
NTERFACE
Description
This command is entered in the interface
configuration mode to administratively
bring up the interface.
This command is entered in the interface
configuration mode to administratively
bring down the interface.
277
Beta