Ethernet Configuration; Ethernet Interface Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

E C
THERNET ONFIGURATION
Refer to the following sections to configure an Ethernet interface on the OA-700.
E I
THERNET NTERFACE
This section lists the step by step instructions to configure Ethernet interface.
Step 1: Enter into Configuration Mode.
Step 2: Configure Gigabit Ethernet interface. See
Step 3: Administratively bring up the interface.
Step 4: Configure IP address for the interface.
Step 5: Configure parameters that are optional on the interface.
•
•
•
•
Step 6: View the configuration details on the interface. See
Show Commands".
Step 7: Clear interface statistics. See
CLI Configuration Guide
Beta
C S
ONFIGURATION TEPS
ALU# configure terminal
ALU(config)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
Configure Duplex Operation on the interface. See
Operation"
Configure Flow control on the interface. See
Configure MTU on the interface. See
Transmission Unit) on the Interface"
Configure Speed on the interface. See
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
"To Configure GigE Interface"
"To Configure Flow Control"
"To Configure MTU (Maximum
"To Configure Speed"
"Ethernet Interface
"Ethernet Interface Clear

Ethernet Configuration

"To Configure Duplex
Commands".
155
Beta