Partial Help; Partial Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
The Command Line Interface
P H
ARTIAL ELP
When you enter a partial command (part of a command) and press the TAB or
SPACE key, the command line parser completes the command if the string
entered is unique to the command mode. For this to happen, service completion
should have been enabled for the key.
For example, if you enter conf in the SUM mode, this entry is associated with the
configure command.
E
XAMPLE
ALU# conf <Tab>
ALU# configure
When you use the command completion feature the CLI displays the full
command name. The command is not executed until you use the Return or Enter
key. This way you can modify the command if the full command was not what you
intended by the abbreviation.
If the CLI cannot complete the command, it displays the list of commands that
begin with that set of characters.
For example, typing show ip i<tab> will list all commands, which start with "show
ip i" in the current command mode:
ALU(config)# show ip i<tab>
igmp
ALU(config)# show ip i"
Note: Characters you enter before the question mark are reprinted to the screen to allow
you to complete the command entry.
P C
ARTIAL OMMANDS
When you enter a partial command (part of a command) and press the Enter key,
the CLI executes the best matched command.
E
XAMPLE
ALU(config)# sh ip int br
Interface
GigabitEthernet3/0
GigabitEthernet3/1
30
Beta
interface
IP Address
unassigned
10.91.1.146
Alcatel-Lucent
Admin State Oper State
up down
up up
CLI Configuration Guide
Beta