PVST+ C
ONFIGURATION
Refer to the following sections to configure PVST+ on your system:
•
"PVST+ Configuration Steps"
•
"PVST+ Configuration Flow"
•
"PVST+ Configuration Commands"
•
"Show Commands in PVST+"
PVST+ C
ONFIGURATION
This section lists step by step instructions to be followed while configuring the
PVST+.
Step 1: Enter Configuration Mode.
ALU# configure terminal
ALU(config)#
Step 2: Enable PVST+. See
Step 3: To configure Forward-time / Hello-time / Max-age / Priority for PVST+.
See
"To Set Forward-time / Hello-time / Max-age / Priority for PVST+"
Step 4: Configure L2 interface.
Configure PVST+ Optional parameters on a L2 interface:
•
To disable/enable PVST+ on an L2 interface. See
on an Interface"
•
Set the PVST+ cost. See
•
Set the Port-priority. See
Step 5: Use the show commands to recheck and view the details configured. See
"Show Commands in PVST+"
CLI Configuration Guide
Beta
S
TEPS
"To Enable PVST+"
ALU(config)# interface switchport <slot/port>
ALU(config-if switchport<slot/port>)#
Example:
ALU(config)# interface switchport 1/0
ALU(config-if switchport1/0)#
"To Calculate the PVST+ Cost"
"To Set PVST+ Port Priority"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
"To Disable/Enable PVST+
PVST+ Configuration
(Optional)
185
Beta