Filter Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

F C
ILTER ONFIGURATION
The following steps are used to configure a filter on the OA-700:
T C F
O REATE A ILTER
ip filter <name>
E
XAMPLE
ALU(config)# ip filter f1
ALU(config-filter-f1)#
T C
O ONFIGURE A
Command (in FCM)
[<1-65535>] match [any|all]
<match-list name>...
{permit|deny [reset]}[log]
[verbose] [timer <timer-
object>]
default {deny|permit}[log]
[verbose]
Note: The 'reset' keyword can be used in conjunction only with the "deny" keyword.
CLI Configuration Guide
Beta
C
OMMANDS
Command (in CM)
R F
ULE FOR A ILTER
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command configures a filter.
Description
This command is used to configure rules
(associate match-lists and set priority for
the rule) for a filter, and also set the
action deny or permit for the configured
rules.
By default, 'any' keyword is used.
The range for the rule number is 1-
65535. This rule number signifies the
priority of a rule. By default, the
numbering pattern for rule number is the
next multiple of ten to the highest existing
rule number.
Reset: Use this keyword to send a reset
packet to the sender.
Log: Use this keyword to log the packet
information.
Verbose: This logs all packets of a
session.
Timer object: The name of the time
range.
This command sets an action of either
permit or deny on the filter.
The default action for a filter is
"deny".
Filter Configuration
655
Beta