L2 Switching Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

L2 S C
WITCHING OMMANDS
T C L2 I
O ONFIGURE AN NTERFACE
interface switchport <slot/
port>
E
XAMPLE
ALU(config)# interface switchport 1/0
ALU(config-if switchport1/0)#
T A B
O DMINISTRATIVELY RING
no shutdown
shutdown
E
XAMPLE
ALU(config-if switchport1/0)# no shutdown
T C M
O ONFIGURE ODE FOR THE
switchport mode {trunk|hybrid}
no switchport mode
E
XAMPLE
ALU(config-if switchport1/0)# switchport mode trunk
ALU(config-if switchport1/0)# no switchport mode
CLI Configuration Guide
Beta
Command (in CM)
U /D L2 I
P OWN THE NTERFACE
Command (in ICM)
L2 I
NTERFACE
Command (in ICM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
L2 Switching Configuration
Description
This command is used to configure an
L2 interface.
Description
This command is used to
administratively bring up the L2
interface.
This command is used to
administratively bring down the L2
interface.
Description
This command is used configure the L2
interface in the trunk or hybrid mode.
This command first removes the hybrid/
trunk mode configured on the interface.
If the interface is configured with access
VLAN configuration, it changes to
access mode since it takes precedence
over the bridging mode. If no access
VLAN is configured, then the interface
moves to pure bridging mode.
171
Beta