Tf Configuration; Tf Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

TF C
ONFIGURATION
This section includes the following:
•

"TF Configuration Steps"

•
"TF Configuration Flow"
•
"TF Configuration Commands"
•
"Show Commands in TF"
•
"Clear Commands in TF"
TF C S
ONFIGURATION
This section lists the steps for configuring TF on the OA-700.
Configure TF on an Interface
Step 1: Enter into Interface Configuration Mode
Step 2: Administratively bring up the interface
Step 3: Configure TF on an interface, and optionally attach TF policy (See Step
4) on the interface. See
Note: An interface can have only one TF policy applied on it at any time.
Step 4: Configure TF policy (Optional)
•
•
Step 5: Use the show commands to view TF configuration. See
Commands in TF"
CLI Configuration Guide
Beta
TEPS
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
"To Configure TF on an Interface"
Configure a TF policy. See
Configure pass through protocol. See
Protocol"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
"To Configure a TF Policy"
"To Configure Pass Through

TF Configuration

"Show
857
Beta