Lfi - Mlppp Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

LFI - MLPPP C
ONFIGURATION
Fragmentation is performed before transmitting the packet on the link based on
the fragment delay parameter configured on the MLPPP bundle interface. Based
on the link speed and fragment delay, fragment size is calculated. Data as well as
voice packets will be fragmented as long as the packet size is greater than the
fragment size. All the fragments of a packet will be sent through the same MLPPP
link. QoS will classify the fragments/packets stream and perform interleaving
functionality between voice and data packets.
Reassembly is performed after receiving the fragments from the links irrespective
of LFI enabled on the receiving side. Based on the slippage parameter
configuration, buffer is allocated on the receiver side. Once the buffer is full, the
first unassembled packet is dropped.
T A P M
O TTACH A OLICY AP TO THE
service-policy {in|out}
<policy-map name>
no service-policy {in|out}
<policy-map name>
E
XAMPLE
ALU(config)# interface mlppp 100
ALU(config-if mlppp100)# service-policy out P1
ALU(config-if mlppp100)# no service-policy out P1
Note: In the above example, P1 is the QoS policy map attached to the interface.
Configurations for the QoS policy map and the attributes within the policy is not shown
in this section. For more information on configuring policy map, refer to QoS
Configuration section in the
CLI Configuration Guide
Beta
C
OMMANDS
MLPPP I
NTERFACE
Command (in ICM)
"Quality of Service"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
LFI Configuration on MLPPP
Description
This command is entered in the Interface
Configuration mode.
This command is used to attach a policy
map to the MLPPP interface.
This command detaches the policy map
from the interface.
chapter.
385
Beta