Point-To-Point Protocol; Chapter Conventions - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

C 15
HAPTER
This chapter includes the commands for configuring Point-to-Point Protocol (PPP)
encapsulation on a T1 or E1 interface or a Serial Interface (V.35/X.21). You are
required to refer to the
Card" chapters before proceeding to this.
This chapter includes steps to configure PPP (LCP, IPCP, Timers and Counters,
authentication), and troubleshoot PPP through the CLI. For instructions on using
the PPP commands and descriptions on each of their parameters, refer to the
OmniAccess 700 CLI Command Reference Guide.
Refer to the following to configure PPP encapsulation on an interface:
•
"PPP Overview"
•
"PPP Configuration"
C C
HAPTER ONVENTIONS
Acronym
CM
CHAP
EAP
HDLC
ICM
IPCP
LCP
MTU
NCP
PAP
PPP
SUM
CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
P - -P
OINT TO OINT
"T1E1 Line Card"
Configuration Mode - ALU (config)#
Challenge Handshake Authentication Protocol
Extensible Authentication Protocol
High Level Data Link Control
Interface Configuration Mode - ALU (config-interface name)#
IP Control Protocol
Link Control Protocol
Maximum Transmission Unit
Network Control Protocol
Password Authentication Protocol

Point-to-Point Protocol

Super User Mode - ALU #
Alcatel-Lucent
P
ROTOCOL
and "Universal Serial Port (USP) Line
Description
Point-to-Point Protocol
311
Beta