V.35/X.21/Rs-232 Dte And Dce Cli Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Universal Serial Port (USP) Line Card
V.35/X.21/RS-232 DTE
T C C R
O ONFIGURE LOCK
The clock rate command enables you to configure the speed of the clock.
clockrate {64000|128000|256000
|512000|1024000|2048000}
no clockrate
{64000|128000|256000
|512000|1024000|2048000}
E
XAMPLE
ALU(config-if Serial0/0)# clockrate 256000
ALU(config-if Serial0/0)# no clockrate
Note: In RS-232 mode, maximum clock rate of 256 Kbps is supported.
T C CRC
O ONFIGURE
crc {16|32}
no crc {16|32}
E
XAMPLE
ALU(config-if Serial0/0)# crc 16
ALU(config-if Serial0/0)# no crc
278
Beta
DCE CLI C
AND
ATE
Command (in ICM)
Command (in ICM)
Alcatel-Lucent
C
ONFIGURATION OMMANDS
Description
This command configures the clock rate.
The "no" command sets the clock rate to
default 64000 bps.
Description
32: This command enables the 32 bit
CRC.
16: This command enables the 16 bit
CRC.
The "no" command sets CRC to default
value 16.
CLI Configuration Guide
Beta