Filter Configuration; Filter Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Filter and Firewall
F C
ILTER ONFIGURATION
Refer to the following sections to configure filter:
•

"Filter Configuration Steps"

•
"Filter Configuration Flow"
•
"Filter Configuration Commands"
•
"Filter Show Commands"
•
"Filter Deletion Commands"
•
"Filter Debug Commands"
•
"Sample Examples of Configuring Filters on OA-700"
F C
ILTER ONFIGURATION
This section lists the steps to be followed while configuring a filter.
Step 1: Configure the match-lists using the common classifiers syntax. (Refer to
the chapter on
Step 2: Configure a filter. See
•
Step 3: Configure Filter Optional Parameters.
•
•
Step 4: Enter into Interface Configuration Mode
Note: Filter can be configured on Gigabit Ethernet, Loopback, Serial, Tunnel, VLAN
interfaces.
Step 5: Administratively bring up the interface
652
Beta
S
TEPS
"Common Classifiers"
"To Create a Filter"
Configure Rule for a filter. See
Configure a stateless filter. See
Reorder the rules in the filter. See
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Alcatel-Lucent
in this guide).
"To Configure a Rule for a Filter"
"To Configure a Stateless Filter"
"To Reorder the Rules in the Filter"
CLI Configuration Guide
Beta