Verifying Multicast Routing - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

V M
ERIFYING ULTICAST
Show command outputs on router R3 is given. It shows the outgoing interface list
for each (*,G) entry. You can use "show ip multicast traffic" command to verify the
packet reception and forwarding.
R3(config)# show ip pim state-info
PIMv2 State information
Flags: M - Nexthop from Mroute, T - Terminating, A - Reported by IGMP
K - KeepAlive Timer Running, S - SPT bit set
(*,225.5.5.5), JOINED 00:01:10/00:00:49, RP 3.3.3.2, flags:
Incoming interface: GigabitEthernet7/1, RPF neighbor 3.3.3.2
Downstream interface state:
Serial0/0:0, 00:01:10, flags:
(*,G): JOIN
inherited_olist: Serial0/0:0
(*,227.7.7.7), JOINED 00:09:26/00:00:34, RP 3.3.3.2, flags:
Incoming interface: GigabitEthernet7/1, RPF neighbor 3.3.3.2
Downstream interface state:
GigabitEthernet7/0, 00:09:26, flags:
(*,G): JOIN
Serial0/0:0, 00:00:16, flags:
(*,G): JOIN
inherited_olist: GigabitEthernet7/0 Serial0/0:0
R3(config)#
R3(config)# show ip mroute
IP Multicast Forwarding Information Base
Flags: R - RP-bit set, T - SPT-bit set
F - Register flag, J - Joined
(*, 225.5.5.5), uptime 0:01:59, flags:
Incoming Interface: GigabitEthernet7/1, RPF failures 0
Outgoing Interfaces (1):
Serial0/0:0
(*, 227.7.7.7), uptime 0:10:15, flags:
Incoming Interface: GigabitEthernet7/1, RPF failures 0
Outgoing Interfaces (2):
GigabitEthernet7/0
Serial0/0:0
R3(config)#
R3(config)# show ip multicast traffic
IP Multicast statistics:
Rcvd:
Sent:
Errors:
R3(config)#
CLI Configuration Guide
Beta
R
OUTING
ET:00:03:20
ET:00:03:02
ET:00:03:14
11134 total, 4802 link local
5973 forwarded, 0 send register
5 send assert, 1 first data pkt notice
5 rpf failure, 5 drop
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Multicast Configuration on OA-700
PPT:00:00:00
PPT:00:00:00
PPT:00:00:00
575
Beta