Nat Deletion Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Network Address Translation
NAT D C
ELETION OMMANDS
This section explain how to delete NAT configurations.
T D NAT P
O ELETE A OLICY
no ip nat <name>
E
XAMPLE
If the NAT 'N1' is to be deleted, use the following command:
ALU(config)# no ip nat N1
If a NAT policy is attached to an interface, first detach it before deleting.
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)# no ip nat out nat1
T E D
O NFORCE ELETION OF
no ip nat <name> force
E
XAMPLE
To force deletion of the NAT N1:
ALU(config)# no ip nat N1 force
644
Beta
Command (in CM)
NAT G
LOBALLY
Command (in CM)
Alcatel-Lucent
Description
This command is used to delete a
specific NAT policy when it is not
attached to any interface.
Description
The "force" keyword will automatically
detach the specified NAT policy from
respective interfaces, and deletes the
policy.
This command when used also deletes
all the associated NAT policy rules.
CLI Configuration Guide
Beta