Configuration; V.35/X.21/Rs-232 Interface Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

V.35/X.21/RS-232 C
Refer to the following sections to configure V.35/X.21/RS-232 interface on OA-
700:
•

"V.35/X.21/RS-232 Interface Configuration Steps"

•
"V.35/X.21/RS-232 Configuration Flow"
•
"V.35/X.21/RS-232 Configuration Commands"
•
"V.35/X.21/RS-232 DTE and DCE CLI Configuration Commands"
V.35/X.21/RS-232 I
NTERFACE
This section lists the instructions to configure V.35/X.21/RS-232 interface.
Step 1: Enter Configuration Mode
ALU# configure terminal
ALU(config)#
Step 2: Configure a Serial interface. See
Step 3: Administratively bring up the interface. See
(V.35/X.21/RS-232) Interface"
Step 4: Configure IP address for the interface
Step 5: Configure optional parameters for V.35/X.21/RS-232 DTE and DCE.
See "V.35/X.21/RS-232 DTE and DCE CLI Configuration Commands"
•
•
•
•
•
•
Step 6: See
CLI Configuration Guide
Beta
ONFIGURATION
C
ONFIGURATION
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if Serial0/0)# ip address 20.20.20.20/24
Configure Clock Rate. See
Configure CRC. See "To Configure CRC"
Configure Clock Inversion. See
Configure Loopback. See
Set Encapsulation. See
Configure MTU. See "To Configure MTU (Maximum Transmission Unit)"
"Show Command" to view the interface configuration.
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
V.35/X.21/RS-232 Configuration
S
TEPS
"To Configure a Serial Interface"
"To Bring Up/Down a Serial
"To Configure Clock Rate"
"To Configure Invert Transmit Clock"
"To Configure Loopback"
"To Set Encapsulation"
275
Beta