Management Plane Overview; Out Of Band Management (Console Or Modem) - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
System Configuration and Monitoring
M P
ANAGEMENT
The OA-700 extends the approach of control/data plane separation by introducing
a management plane. This separation is reflected in the actual architecture of the
system on a number of different levels including hardware and software. The
management plane, as the name implies, handles all the aspects of managing the
system.
The management functions of most of the network devices are directly accessible
through the network that the router is connected to and through dedicated
management ports. Managing the router, through any of the network interfaces, is
called 'in-band' management. Contrarily, management through any of the
dedicated management ports, such as console or modem, are commonly referred
to as 'out-of-band' management.
O B M
UT OF AND ANAGEMENT
C A
ONSOLE CCESS
The console port is located in the front panel of the OA-700. The console
parameters can be set with the commands given below.
[no] line console exec-timeout
<0-35791> [<0-60>]
line console baudrate
{115200|19200|2400|
38400|4800|57600|9600}
E
XAMPLE
ALU(config)# line console exec-timeout 0
ALU(config)# line console exec-timeout 45 15
ALU(config)# no line console exec-timeout
ALU(config)# line console baudrate 19200
44
Beta
O
LANE VERVIEW
(C
ONSOLE OR
Command (in CM)
Alcatel-Lucent
M )
ODEM
Description
This command is used to configure the
timeout (in minutes or seconds) for
console session. The console CLI
session closes if it is idle for the specified
time.
The default timeout is 20 minutes.
A zero input specifies that the console
CLI should never exit when left idle.
This command is used to configure baud
rate.
Default baudrate is 9600.
CLI Configuration Guide
Beta