Ipsec Vpn Configuration; Ipsec Vpn Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
IP Security - Virtual Private Network
IP VPN C
SEC ONFIGURATION
Refer to the following sections for configuring IPsec:
•

"IPsec VPN Configuration Steps"

•
"IPsec VPN Configuration Flow"
•
"IPsec Configuration Commands"
•
"IPsec VPN Show Commands"
IP VPN C
SEC ONFIGURATION
The following are the steps to configure IPsec VPN on the OA-700:
Step 1: Configure the match-lists with the pre-configured common classifiers.
(Refer to the
Step 2: Configure a preshared key. See
OR
Configure X.509 certificates. See
Step 3: Configure IKE policy. See
Step 4: Configure a Transform Set. See
Step 5: Configure Crypto Map. See
Step 6: Enter the Interface Configuration Mode
Step 7: Administratively bring up the interface
750
Beta
S
TEPS
"Common Classifiers" chapter in this guide).
"IPsec Configuration with X.509 Certificates"
"To Configure an IKE Policy"
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Alcatel-Lucent
"IPsec Configuration with Preshared Key"
"To Configure Transform-set in IPsec"
"To Configure IPsec Crypto Map"
CLI Configuration Guide
Beta