Mlfr Show Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T C R
O ONFIGURE THE ETRY
Retry count is the number of times the bundle link will send out a hello message
before any acknowledgment is received from its peer.
mlfr retry-count <1-5>
no mlfr retry-count <1-5>
E
XAMPLE
ALU(config-if Serial0/0:0)# mlfr retry-count 3
ALU(config-if Serial0/0:0)# no mlfr retry-count 3
MLFR S C
HOW OMMANDS
T V MLFR C
O IEW ONFIGURATION
Command (in SUM/CM)
show interfaces mlfr [<1-256>]
show mlfr [<1-256>]
show interfaces Serial [<slot/
port:channel>]
E
XAMPLE
ALU(config)# show interfaces mlfr 1
mlfr1 is up, line protocol is up
Internet address is 192.168.1.1/24
Bundle id is mlfr1,
LMI enq sent 26219, LMI stat recvd 325, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent
LMI DLCI 0 LMI type is CCITT(q933a)
MTU 1500 bytes, BW 3072 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation mlfr-bundle, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
614 packets input( 325 controld packets, 289 data packets),34295 bytes
26599 packets output( 26216 controld packets, 383 data packets),458430 bytes
53 packets dropped 0 giant packets
CLI Configuration Guide
Beta
C
OUNT
Command (in ICM)
keepalive set (10 sec)
0, LMI upd sent
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command configures the retry count
to the number specified. The range of
this number is from 1 to 5.
This command resets the retry count to
its default, i.e., 2.
Description
Displays the configuration of the MLFR
bundle interface specified.
Displays the protocol status on the
member links of the specified MLFR
bundle interface.
Use this command to verify if MLFR is
the current encapsulation on the
interface, and to check the interface
details.
0
frame relay DTE
MLFR Configuration
373
Beta