Updations - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Network Address Translation
U
PDATIONS
This section explains how to update a NAT rule.
T R L
O ENUMBER THE IST
By default, the numbering pattern used in OA-700 is multiples of ten. If a new
match-list is to be included in-between two existing match-lists without actually
changing the sequence of numbering, use the "renumber" keyword.
This command normalizes the line numbers of each rule, and sets them to the
consecutive multiples of 10.
E
XAMPLE
Consider the following example:
ip nat N1
10
20
30
25
This generates a numbering scheme without a proper order. The output of the
show command will be:
ip nat N1
10
20
25
30
The keyword "renumber" is used to re-order the numbers to the original scheme.
ALU(config-nat-N1)# renumber
The output of the show command would now be:
ip nat N1
10
20
30
40
642
Beta
match M1 source-nat
match M2 source-nat
match M3 source-nat
match M4 source-nat
match M1 source-nat
match M2 source-nat
match M4 source-nat
match M3 source-nat
match M1 source-nat
match M2 source-nat
match M4 source-nat
match M3 source-nat
Alcatel-Lucent
CLI Configuration Guide
Beta