Idle Timeout; Example; Ping - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
System Configuration and Monitoring
I T
DLE IMEOUT
The idle timeout for SSH, Telnet and Modem CLI sessions can be set by using the
following command:
[no] line vty exec-timeout
<0-35791> [<0-60>]
E
XAMPLE
ALU(config)# line vty exec-timeout 0
ALU(config)# line vty exec-timeout 45 15
ALU(config)# no line vty exec-timeout
P
ING
The ping command is used to check the connectivity to a specific host using the
IP address/host name of that host.
ping [vrf <vrf-name>] {<ip-
address>|<hostname>}
E
XAMPLE
ALU> ping 192.168.10.121
Sending 5,64-byte ICMP Echos to 192.168.10.121,
timeout is 10 seconds
!!!!!
Success rate is 100 percent (5/5),
round-trip min/avg/max = 0.124/0.191/0.356 ms
50
Beta
Command (in CM)
Command (in UM)
Alcatel-Lucent
Description
This command is used to configure the
timeout (in minutes or seconds) for SSH,
Telnet, and Modem CLI sessions. These
sessions close if they are idle for the
specified time.
The default timeout is 20 minutes.
A zero input specifies that the SSH,
Telnet and Modem CLI sessions should
never exit when left idle.
Description
Use this command to check the
connectivity between OA-700 and any
remote machine.
CLI Configuration Guide
Beta