T1 Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T1 C C
ONFIGURATION
This section comprises the commands that are used in configuring the T1
controller.
T S C
O ET THE ARD TYPE TO
card type {E1|T1} <slot>
E
XAMPLE
ALU(config)# card type T1 0
Note: The line card is not functional until card type is set. Reboot/Reload the chassis to
change the card type, which will remove the previous configuration. Use controller
and channel-group commands to relaod the card type.
T C T1 C
O ONFIGURE ONTROLLER
controller {E1|T1} <slot/port>
E
XAMPLE
ALU(config)# controller T1 0/0
ALU(config-controller T1)#
CLI Configuration Guide
Beta
OMMANDS
T1
Command (in CM)
Command (in CM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Use this command to set the card
type.
Use T1 keyword to set the card type
to T1.
Description
This command configures a E1 or T1
controller.
Use T1 keyword to configure a port in
the T1 mode. The T1 has a bandwidth
of 1.544 Mbps.
T1 Configuration
259
Beta