Tf Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

TF C C
ONFIGURATION
The following steps are used for TF configuration:
T C TF
O ONFIGURE ON AN
transparent-forward [<tf-
policy-name>] interface
<interface-name>
no transparent-forward [<tf-
policy-name>]
Note: The outgoing interface cannot be the same as incoming interface.
You can configure an IP address on an interface for management purpose.
E
XAMPLE
The following configures TF feature and binds the TF policy 'TF1' on the interface
GigabitEthernet3/0 with outgoing interface as VLAN 10.
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# transparent-forward TF1
interface Vlan 10
If the TF policy 'TF1' is attached to the GigabitEthernet3/0, the following command
detaches it from the interface:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# no transparent-forward
TF1
CLI Configuration Guide
Beta
OMMANDS
I
NTERFACE
Command (in ICM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command is entered in the
Interface Configuration mode.
This command is used to configure TF
feature on an interface (incoming
interface). Use the interface keyword
to configure the outgoing interface.
You can optionally apply a TF policy
(that defines the treatment of non-IP
and non-ARP packets) on the interface.
Note: The 'IP Policy' command, if
in effect, shall be cleaned
up before this command
takes effect.
This command removes the TF feature
on the interface, and detaches the TF
policy attached to an interface, if
specified.
TF Configuration
859
Beta