Pppoe Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Point-to-Point Protocol over Ethernet (PPPoE)
PPP E C
O ONFIGURATION
This section lists the commands for PPPoE configuration.
Step 1: Enter the Configuration Mode
Step 2: Configure Gigabit Ethernet interface. Enters Interface Configuration
Mode.
Step 3: Administratively bring up the interface.
Note: The IP address configuration is optional when PPPoE encapsulation is configured on
the GigE interface. The operational mode is always PPPoE client.
The client gets the IP address from the PPPoE server, whenever the IPCP negotiation
happens. For this, you need to configure "ppp ipcp address accept-local" on the
interface.
For more details on this, refer to the IPCP configuration section documented in the
"Point-to-Point Protocol"
Step 4: Configure PPPoE encapsulation on the interface. See
Encapsulation on the
Step 5: Configure service name for PPPoE. See
Name".
Step 6: Configure PPPoE Optional Parameters. See
Parameters"
•
•
338
Beta
S
TEPS
ALU# configure terminal
ALU(config)#
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
chapter.
Interface".
Initiate PPPoE negotiation. See
Configure PPPoE retry timer. See
PADI/PADR Packets"
Alcatel-Lucent
"To Set PPPoE
"To Configure PPPoE Service
"PPPoE Optional
"To Initiate PPPoE Negotiation Manually"
"To Set Timer for Retransmission of
CLI Configuration Guide
Beta