Ospf Configuration; Ospf Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

OSPF C
ONFIGURATION
This section includes the following:
•

"OSPF Configuration Steps"

•
"OSFP Configuration Flow"
•
"OSPF Configuration Commands"
•
"Show Commands in OSPF"
•
"Clear Commands in OSPF"
OSPF C
ONFIGURATION
The steps given below helps in configuring and running basic OSPF on the
OA-700.
Step 1 to Step 5 are the minimum configuration requirements for enabling
OSPF. Step 6 describes other important but optional configuration
commands for OSPF.
Step 1: Configure an interface. Enter Interface Configuration Mode.
Note: OSPF can be configured on GigabitEthernet, Serial, Tunnel, VLAN, Loopback
interfaces.
Step 2: Administratively bring up the interface
Step 3: Configure IP address for the interface
Step 4: Enable OSPF. See
CLI Configuration Guide
Beta
S
TEPS
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
"To Enable OSPF"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

OSPF Configuration

511
Beta