Filter Debug Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

F D C
ILTER EBUG OMMANDS
This section details the debug commands used in Filter configuration.
T E /D D
O NABLE ISABLE EBUGGING ON
Command (in SUM)
debug firewall {session|
filter|nat|attack|alg|
intrusion|selector [saddr <ip-
address>|daddr <ip-address>|
protocol <number>|sport
<number>|dport <number>]
[output|permanent]| all
[detail-level]}
no debug firewall {session|
filter|nat|attack|alg|
intrusion|selector [saddr <ip-
address>|daddr <ip-address>|
protocol <number>|sport
<number>|dport <number>]
[output|permanent]| all
[detail-level]}
Notes: 1. saddr == source address
2. daddr == destination address
3. sport == source port
4. dport == destination port
E
XAMPLE
The example below enables debugging for the source IP 10.91.0.52
ALU# debug firewall selector saddr 10.91.0.52
The example below disables debugging for the source IP 10.91.0.52
ALU# no debug firewall selector saddr 10.91.0.52
CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
F
ILTER
This command turns on debugging for
the filter statistics configured.
The "selector" keyword is used to debug
only selected traffic.
This command turns off the debugging
functionality.
The "selector" keyword is used to turn
off debugging only for selected traffic.
Alcatel-Lucent
Filter Configuration
Description
Beta
663