Vrrp Configuration; Vrrp Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

VRRP C
ONFIGURATION
Refer the following sections to configure VRRP on your OA-700:
•

"VRRP Configuration Steps"

•
"VRRP Configuration Flow"
•
"VRRP CLI Commands"
VRRP C
ONFIGURATION
The following are the steps to be followed when configuring VRRP:
Step 1: Enter into Configuration Mode.
Step 2: VRRP is configured on an interface. First, configure an interface.
Note: The interface IP address must be configured and the operational state of the interface
must be up for VRRP to operate.
Step 3: Administratively bring up the interface
Step 4: Configure IP address for the interface
Step 5: Configure VRRP on the interface and configure primary IP address for the
VRRP Group. See
Group"
Step 6: Configure the optional parameters for the VRRP group like: Secondary
IP address for the VRRP Group, Authentication, Priority, Preempt, Description,
Set an Advertisement interval, Learning the advertisement interval, interface
tracking. See
CLI Configuration Guide
Beta
S
TEPS
ALU# configure terminal
ALU(config)#
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
"To Configure VRRP Group and Primary IP Address for the
"Modify Global VRRP Group Parameters"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

VRRP Configuration

133
Beta