T1 Configuration; T1 Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
T1E1 Line Card
T1 C
ONFIGURATION
Refer to the following sections to configure a T1 line card on your OA-700:
•

"T1 Configuration Steps"

•
"T1 Configuration Flow"
•
"T1 Configuration Commands"
•
"T1 Show Commands"
•
"Troubleshooting T1 Lines"
T1 C S
ONFIGURATION
Following are the steps to configure T1 interface:
Step 1: Set the card type to T1
Step 2: Enter Controller Configuration Mode. See
Step 3: Configure channel-groups on the controller before entering into interface
configuration mode. See
channel-group that will form a channelized serial interface.
Step 4: Administratively bring up the T1 controller. See
the T1 Controller"
Step 5: Configure Optional parameters for T1. See
Parameters for T1 Controller"
•
•
•
•
Step 6: Enter Interface Configuration Mode to configure the channelized serial
interface. See
Note: Creation of a channel-group is a pre-requisite prior to configuring a serial interface.
256
Beta
TEPS
""To Set the Card type to T1"
"To Configure Channelized
Configure cablelength. See
Configure a Long Cablelength"
Configure framing. See
Configure linecoding scheme. See
Configure clocksource. See
"To Configure a Serial Interface"
Alcatel-Lucent
"To Configure T1 Controller"
T1". This command creates a
"To Bring Up/Shutdown
"Configure Optional
"To Configure a Short
"To Configure Framing on T1"
"To Configure Linecoding on T1"
"To Configure Clocksource"
Cablelength", "To
CLI Configuration Guide
Beta