Hdlc Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
High-level Data Link Control
HDLC C
ONFIGURATION
This section details the HDLC configuration commands.
T S E
O ET NCAPSULATION TO ITS
Enter this command in the Interface Configuration Mode.
no encapsulation {frame-relay
|ppp|mlppp|mlfr}
E
XAMPLE
ALU(config-if Serial0/0:0)# no encapsulation frame-relay
T C HDLC E
O ONFIGURE NCAPSULATION
encapsulation hdlc
E
XAMPLE
ALU(config-if Serial0/0:0)# encapsulation hdlc
290
Beta
C
OMMANDS
D (HDLC)
EFAULT
Command (in ICM)
Command (in ICM)
Alcatel-Lucent
Description
This command is used to configure
encapsulation on the interface to HDLC.
This command is applicable only if the
encapsulation is already set to Frame
Relay or PPP.
Description
This command is entered in the Interface
Configuration Mode.
This command is used to configure
encapsulation on an interface to HDLC.
CLI Configuration Guide
Beta