Pim Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Multicast Routing
PIM C
ONFIGURATION
To configure PIM, perform the tasks described in the following sections. The tasks
in the first section are required; the tasks in the remaining sections are optional,
but might be required for your network.
T E M R
O NABLE ULTICAST
ip multicast-routing
E
XAMPLE
ALU(config)# ip multicast-routing
T E PIM I
O NABLE ON AN NTERFACE
ip pim sparse-mode
no ip pim sparse-mode
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
552
Beta
C
OMMANDS
OUTING
Command (in CM)
Command (in ICM)
Alcatel-Lucent
Description
This command enables multicast routing
and forwarding on OA-700.
Multicast routing is disabled by default.
Description
Enter this command in the Interface
Configuration Mode.
This command is used to enable PIM on
an interface.
After enabling this command, PIM starts
sending hello packets to form
neighborship.
This command is used to disable PIM on
an interface.
CLI Configuration Guide
Beta