Troubleshooting T1 Lines - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T T1 L
ROUBLESHOOTING
This section lists the commands to troubleshoot the T1 line cards.
T E L
O NABLE OOPBACK
loopback {local|network
{line|payload}|remote {line-
|payload}}
no loopback
E
XAMPLE
The following example establishes a loopback of the incoming T1 signal on
controller T1 0:
ALU(config)# controller T1 0/0
ALU(config-controller T1)# loopback network payload
The following example disables the loopback on the controller T1 0:
ALU(config)# controller T1 0/0
ALU(config-controller T1)# no loopback
CLI Configuration Guide
Beta
INES
Command (in CCM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Use the loopback controller
configuration command to put the T1
or E1 line into loopback mode. It can
be used to verify connectivity.
The "no" command disables the
loopback mode set on the interface.
The default loopback for T1 lines
is Local.
T1 Configuration
269
Beta