Igmp Configuration; Igmp Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

IGMP C
ONFIGURATION
This section includes the following:
•

"IGMP Configuration Steps"

•
"IGMP Configuration Flow"
•
"IGMP Configuration Commands"
•
"Show Commands in IGMP"
IGMP C
ONFIGURATION
The steps given below helps in configuring IGMP routing on the OA-700.
Step 1: Configure an interface. Enter Interface Configuration Mode.
Note: IGMP can be configured on Layer 3 interfaces.
Step 2: Administratively bring up the interface
Step 3: Configure IP address for the interface
Step 4: Enable Multicast routing. See
Step 5: Enable IGMP on an interface:. See
CLI Configuration Guide
Beta
S
TEPS
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
"To Enable Multicast Routing"
"To Enable IGMP on an Interface"

IGMP Configuration

561
Beta