Troubleshooting E1 Lines - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T E1 L
ROUBLESHOOTING
This section lists the commands to troubleshoot the E1 line cards.
C E
OMMANDS TO NABLE AND
Command (in CCM)
loopback {{local|network
{line|payload}|remote
{line|payload}}
no loopback
EXAMPLE
The following configuration establishes a loopback of the incoming E1 signal on
controller E1 0:
ALU(config)#controller E1 1/0
ALU(config-controller E1)# loopback network line
The following example disables the loopback on controller E1 0:
ALU(config)# controller E1 0/0
ALU(config-controller E1)# no loopback
CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
INES
D L
ISABLE OOPBACK
Alcatel-Lucent
Description
Use the loopback controller configuration
command to put the T1 or E1 line into
loopback mode. It can be used to verify
connectivity.
The "no" command disables the loopback
on the interface.
By default, Loopback is disabled for the
E1 lines.
Beta
E1 Configuration
253