Vrf-Ce Configuration; Vrf-Ce Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

VRF-CE C
ONFIGURATION
Refer the following sections to configure VRF-CE on the OA-700:
•

"VRF-CE Configuration Steps"

•
"VRF-CE Configuration Flow"
•
"VRF-CE CLI Commands"
•
"VRF Show Commands"
•
"VRF Clear Commands"
VRF-CE C
ONFIGURATION
This section lists the steps to be followed while configuring VRF-CE.
Step 1: Configure VRF. See
Step 2: Configure routing protocols in VRF.
•
And/Or
•
And/Or
•
And/Or
•
Step 3: Configure Static ARP in VRF. See
(Optional)
Associate VRF to an interface
Step 4: Configure an interface. Enter Interface Configuration Mode.
Step 5: Administratively bring up the interface
OA-780 CLI Configuration Guide
Beta
S
TEPS
"To Configure VRF"
To configure static route in a VRF. See
VRF"
To configure OSPF routing in a VRF. See
To configure BGP routing in a VRF. See
To configure RIP routing in a VRF. See
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
"To Configure Static Route in a
"To Configure OSFP in a VRF"
"To Configure BGP in a VRF"
"To Configure RIP in a VRF"
"To Configure Static ARP in VRF"

VRF-CE Configuration

593
Beta