Rip Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Routing Information Protocol
RIP C
ONFIGURATION
This section lists step by step instructions to be followed while configuring RIP (v1
and v2.) on your system.
Step 1 to Step 5 are the minimum configuration requirements for enabling
RIP. Step 6 describe other important but optional configuration commands
for RIP.
Step 1: Configure an interface. Enter the Interface Configuration Mode.
Step 2: Administratively bring up the interface
Step 3: Configure IP address for the interface
Step 4: Enable RIP. See
Step 5: Configure the major networks to run RIP. See
Network"
Step 6: Configure RIP optional parameters. See
•
•
•
•
470
Beta
S
TEPS
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
"To Enable RIP"
Specify a RIP Version. See
Configure RIP Behavior on an Interface. See
on an Interface"
Enable or Disable Split Horizon. See
Enable or Disable Broadcast Updates. See
Updates"
Alcatel-Lucent
"To Configure a RIP
"RIP Optional Parameters"
"To Specify a RIP Version"
"To Configure RIP Behavior
"To Enable/Disable Split Horizon"
"To Enable/Disable Broadcast
CLI Configuration Guide
Beta