E1 Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

E1 C C
ONFIGURATION
This section provides details about the commands that are used in configuring an
E1 interface.
T S C
O ET THE ARD TYPE TO
card type {E1|T1} <slot>
E
XAMPLE
The following example sets the card type of the E1 controller:
ALU(config)# card type E1 0
Note: The line card is not functional until card type is set. Reboot/Reload the chassis to
change the card type, which will remove the previous configuration. Use controller
and channel-group commands to relaod the card type.
T C E1 C
O ONFIGURE AN ONTROLLER
controller {E1|T1} <slot/port>
E
XAMPLE
ALU(config)# controller E1 0/0
ALU(config-controller E1)#
CLI Configuration Guide
Beta
OMMANDS
E1
Command (in CM)
Command (in CM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Use this command to set the card
type. Use E1 keyword to set the card
type to E1.
Description
This command configures an E1 or T1
controller.
Use E1 keyword to configure an E1
controller.
E1 Configuration
243
Beta