Alg Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

ALG C
ONFIGURATION
This section lists the commands used in configuring an ALG.
Note: Configuring match-lists is a pre-requisite for configuring ALG. (For details, refer to the
chapter "Common Classifiers"
T C ALG
O ONFIGURE
Command (in Match-list Mode)
udp any any service
{dns|nfs|rpc-portmap|sip|tftp}
tcp any any service
{dns|ftp|nfs|rpc-portmap|
rtsp|sip}
E
XAMPLE
ALU(config)# match-list m1
ALU(config-match-list-m1)# udp any any service sip
ALU(config)# match-list m1
ALU(config-match-list-m1)# tcp any any service dns
Note: Use the port number to configure any other standard ALG service apart from those
given in the above commands.
CLI Configuration Guide
Beta
C
OMMANDS
in this guide).
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command is used to enable DNS,
NFS, RPC-Portmap, TFTP, or SIP ALG.
This command is used to enable DNS,
FTP, NFS, RPC-Portmap, RTSP or SIP
ALG.
ALGs Supported in OA-700
713
Beta