Introduction To Cli Modes; Cli User Mode; Cli Configuration Mode; Cli Sub-Configuration Mode (Scm) - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Release versions: 2.2, 2.2-r02, 2.3

Hide thumbs Also See for OmniAccess 700:

Table of Contents

Left running head:

Chapter name (automatic)

The Command Line Interface

NTRODUCTION TO

There are several modes in the CLI, and in each mode, you can perform specific

tasks. The CLI modes can be grouped under three main modes:

In the CLI User Mode, you can enter commands to monitor and troubleshoot the

system, network connectivity, clearing of processes, and routers. At this level,

there are several broad groups of CLI commands. The two main administrative

modes are User Mode (UM) and Super User Mode (SUM). When you log in to the

OA-700 and the start the CLI session, you are at the top level of the CLI User

Mode which is the User Mode (UM).

ONFIGURATION

In the configuration mode, you can configure the OA-700 by creating a hierarchy

of configuration statements by using the CLI or by creating a text (ASCII) file that

contains the statement hierarchy. (The statement hierarchy is identical in both the

CLI and text configuration file).

You can configure different applications running on OA-700 including interfaces,

general routing information, routing protocols, configuring NAT, configuring

firewall, VPN, QoS, and user access as well as several system hardware

There are four different configuration modes: Configuration Mode (CM), Interface

Configuration Mode (ICM), Router Configuration Mode (RCM) and Sub-Interface

Configuration Mode (S-ICM).

ONFIGURATION

From configuration modes, you can enter configuration sub-modes. The sub-

configuration modes are used for the configuration of specific features within the

scope of a given configuration mode.

Alcatel-Lucent

CLI Configuration Guide

Troubleshooting