Network Attack Prevention Configuration; Network Attack Prevention Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

N A
ETWORK TTACK
Refer the following section to prevent network attack:
•

"Network Attack Prevention Configuration Steps"

•
"Network Attack Prevention Configuration Flow"
•
"Network Attack Prevention Configuration Commands"
N A P
ETWORK TTACK
This section lists the steps to be followed to prevent network attacks.
Step 1: Configure the match-lists with the common classifiers pre-configured.
(Refer to the chapter
Step 2: Enter the Firewall Sub Configuration Mode. See
Configuration Mode"
Step 3: Configure DoS attack Object. This enters the Attack Sub Configuration
Mode. See
Step 4: Configure attacks to the configured attack object. See
"To Configure Default Attacks (Rate Limiting / Non-rate Limiting) for an Attack
Object"
OR
"To Configure All Attacks for an Attack Object (Including Default / Optional)"
OR
"To Configure Individual Attack for an Attack Object"
Step 5: Exit from the Attack Sub Configuration Mode
Step 6: Configure Firewall Policy. See
•
Attach a Firewall Policy to an Interface
Step 7: Enter into Interface Configuration Mode
CLI Configuration Guide
Beta
P
REVENTION
C
REVENTION ONFIGURATION
"Common Classifiers"
"To Configure DoS Attack Object"
To create a DoS Rule inside a Firewall Policy. See
Inside a Firewall Policy"
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

Network Attack Prevention Configuration

C
ONFIGURATION
S
TEPS
in this guide).
"To Enter Firewall
"To Configure Firewall Policy"
"To Create a DoS Rule
675
Beta